Diffusion is a slow process so the change in wall thickness takes a lot longer.

If a tube is used, the wall thickness also has an impact on the tone.

The size of a part puts a limit on how thin the wall thickness can be.

The precise value depends only on the wall thickness and the internal pressure.

The pipe wall thickness has a variance of approximately 12.5 percent.

The average wall thickness was the difference of the two diameters divided by 2.

Adjacent wall thickness ratios greater than 2.5 to 1 should be avoided.

This is to accommodate the wall thickness as needed.

Does not require a uniform wall thickness, allowing for greater design flexibility of your base.

The tubes sought by Iraq had a wall thickness of 3.3 millimeters.

However, because cores were often off center, the wall thickness determined the size of the bore.

Cell wall thickness is strongly affected by mechanical stress upon the plant.

The wall thickness of this pipe is one inch.

Pressure resistance and flexibility can also be altered by varying the wall thickness.

The resulting casting has good surface detail but the wall thickness can vary.

Wall thickness is important for corner radii as well.

Reducing the wall thickness to 18 gauge will drop this expense by approximately 60 percent.

In shear forming a reduction of the wall thickness occurs.

Thus for a given pump, the most critical tubing dimension becomes the wall thickness.

Changes such as stiffer materials and increased engine wall thickness (to increase mass) were in place at full production.

All measurements of diameter and wall thickness are performed with built-in software.

The wall thickness of the work piece is directly correlated with the clearance between the punch and die.

For ease of manufacture by casting, the wheels were designed with a constant wall thickness.

Essentially 531 made with reduced wall thickness and heat treated to increase tensile strength.

The wall thickness is uniform around the section.