load resistor

This is true only while the load resistor R3 has a relatively high value.

It is used as substitute for a conventional ohmic load resistor.

The coil formed part of the plate load resistor.

The load line gives you the value for the anode load resistor.

The load line represents a particular value of collector load resistor (R).

No switching is required and no load resistors are needed, so much less power is used.

Thus half the voltage is across the tube at rest, half across the load resistor.

A few power supplies have their own built-in load resistors, so that they can run even though no normal load is plugged in.

The "brown" waveform represents the filtered DC feeding the load resistor.

The rapid switching from tube to tube requires load resistors which absorb a lot of power.

Describe the relationship between source and load resistors in order to minimize the amount of loading error for a real voltage source.

The 609's crosspoint switch buffers each video output and has software selectable load resistors.

- load resistor.

The back shunt was a second tuned circuit consisting of an inductor, a capacitor, and load resistor in series.

The cathode, or bias resistor appears in series with the plate, or load resistor.

The ballast acts, therefore, as a variable load on the system, differing from "load resistors" which have a constant resistance.

This can be improved a little by adding a load resistor to the detector output, but this also has the undesirable effect of decreasing sensitivity.

Changing the grid voltage will change the plate current; by suitable choice of a plate load resistor, amplification is obtained.

When the proper load (e.g., an inductive-capacitive filter plus a load resistor) is used, two things happen.

Therefore, feedback has no effect on the output impedance, which remains simply R as seen by the load resistor R in Figure 3.

The TES is voltage-biased by driving a current source I through a load resistor R (see figure).

When loading a current source with a fixed resistor one can set one determined load current by the connected load resistor.

Calculate the output voltage, V, when in open circuit condition (i.e., no load resistor - meaning infinite load resistance).

An antenna termination load resistor is used with a broadband HF antenna to obtain a non-resonant broad frequency response.

Distortion Analysis Calculates the harmonic distortion generated in a specified load resistor as a result of applying one or more sinusoidal input sources.