The phase converters are no longer responding to input commands.

Static phase converters are actually not a converter at all.

Absolutely," Brim agreed as he stretched forward and opened the phase converter. "

Phase converters are, therefore, used to change both the phase and the frequency.

Another method often attempted is with a device referred to as a static phase converter.

Digital phase converters are designed for fixed-frequency operation from a single-phase source.

Phase converters are used when three-phase equipment needs to be operated on a single-phase power source.

The principle was as follows: A rotating phase converter fed the stators of the motors.

Power capacity of the phase converter (idler horsepower rating).

Selection of the best phase converter for any application depends on the sensitivity of the load to these factors.

Now he gingerly reached out and opened the phase converter itself, gating raw energy into the pulse limiter.

In something closely related to panic, Brim suddenly realized his mistake-the thumb wheel on the phase converter.

Four phase converters have failed.

A digital phase converter creates a three-phase power supply from a single-phase supply.

Rotary phase converters constructed from a three-phase electric motor or generator "idler".

In rural areas farmers who wish to use three-phase motors may install a phase converter if only a single-phase supply is available.

The quality of three-phase power generated by such a phase converter depends upon a number of factors including:

Rotary phase converters are used in the opposite direction (three-phase to single-phase) for electric railways.

Alternatives exist to rotary phase converters for operation of three-phase equipment on a single-phase power supply.

Phase converters are used where three-phase service is not available from the utility, or is too costly to install due to a remote location.

A rotary phase converter (RPC) may be built as a motor-generator set.

After realising that, he also provided the means to build such a rail network by inventing a rotary phase converter suitable for locomotive usage.

This in turn powered a rotary phase converter, which converted the single phase current to three phase 750 V.

I can supply a range of phase converters designed to run three phase motors up to 5 hp from a single phase supply.

A phase converter is a device that converts electric power provided as single phase to multiple phase or vice versa.

A phase changer is used to ensure that the feedback from the collector to base of the detector transistor is positive.

The unacceptably poor cosine phi rate of pre-World War II design electric motors (occasionally as low as 0,65) was not felt outside the Kando locomotives, as the phase changer machinery isolated it from the catenary.