The plane of maximum draught shall be determined at least for Zone 3.

No threat to theCalypso, whose maximum draught at present was just sixteen feet.

Boats may not exceed the dimensions 30x7 metres and a maximum draught of 1.9 metres.

In the foresection of the vessel no floor shall be more than 1,20 m below the plane of maximum draught.

Where necessary in order to meet the requirements in sections 2 or 3, the plane of maximum draught shall be re-established.

(d) The steering system shall be able to be operated by one person, even in maximum draught, without requiring particular force.

Keeping the maximum draught low was an important factor during design, allowing the ships to operate in littoral waters and small harbours.

Maximum draught:

The plane of maximum draught shall be indicated by means of highly visible, indelible draught marks.

The plane of maximum draught shall be determined in such a way that the specifications concerning minimum freeboard and minimum safety clearance are both met.

There are three shipping berths available on Moturoa Wharf, the largest of which is 196 metres with a maximum draught of 9.8 metres.

"plane of maximum draught": the water plane corresponding to the maximum draught at which the craft is authorised to navigate; 55.

The 12-tonne vessel is built of glass-reinforced plastic, has a length of 13 metres with maximum draught at full load 0.90 m and has a bulletproof cabin.

It covers an area of approximately two acres and will accommodate two large canal-size vessels with maximum draught of 12 feet, in addition to numerous smaller vessels.

The Belview Terminal can accommodate ships to approximately 200m length (LOA) with a maximum draught of between 8.5m to 9.3m, depending on tides.

International Marblehead A Marblehead has a maximum length of 1290 mm and a maximum draught of ca 700 mm, but no minimum displacement.

International One Metre The IOM class rules specify a monohull of maximum length 1000 mm, with maximum draught 420 mm.

It offers nine fully serviced berths for a wide variety of cargoes and vessels and provides an official maximum draught of 10 metres which may be exceeded by arrangement.

There are no commercial vessels which ply their trade in this harbour, predominantly because the Bar at the harbour entrance limits the maximum draught (and hence size) of visiting vessels.

It requires cargo vessels with certain characteristics like water tight hatches, having the capacity of transiting in the Seaway System, and with a maximum draught of 23 feet 8 inches.

Maximum draught at LW 8.0m and the draught adjusted accordingly to the height of tide during the LW to HW period, and vice-versa.

At 412 metres long with a maximum draught of 11.6 metres the forestry berth caters for all types of conventional vessels, including fully-laden wood chip carriers, suited to the forestry trade.

The plane of maximum draught is to be set so as to ensure compliance with the safety clearance according to section 1, and the freeboard according to section 2 and Articles 15.02 and 15.03.

Longitudinal bulkheads at a distance of less than B/3 from the outer plating measured perpendicular to centre line from the shell plating at the maximum draught shall not be taken into account for calculation purposes.

The zero points on each draught scale shall be taken vertically to this within the plane running parallel to the plane of maximum draught passing through the lowest point of the hull or of the keel where such exists.