Dodatkowe przykłady dopasowywane są do haseł w zautomatyzowany sposób - nie gwarantujemy ich poprawności.
However, for most applications requiring an appreciable output current, a matching transformer is required.
I therefore decided to remove the link winding and use a wideband matching transformer instead.
The RG58 passes through the toroid to form the secondary of the matching transformer.
Line matching transformers or balancing transformers have been designed for the professional audio market.
For loudspeaker matching transformers, a simple arrangement with the primary and secondary (each in only one section) is adequate.
To convert it to 75 ohm matching Transformer Balun is used.
A matching transformer [5] T will be needed if the oscillator output impedance is higher than that of the speaker.
The feedpoint for the aerial is at the bottom of the loop, and consists of a matching transformer housed in a 35mm film canister.
A matching transformer should be inserted between any such low-impedance transmission line and the higher 470 ohm impedance of the antenna.
External matching transformers are also available that can be used in-line between a low impedance microphone and a high impedance input.
This made the coil act as an impedance matching transformer (in an autotransformer connection) in addition to its tuning function.
For receiving, the antenna may be connected to the receiver directly or through a broadband matching transformer for improved performance over extremely wide bandwidth.
This acts like an impedance matching transformer, allowing most of the wave energy to radiate out the end of the horn into space, with minimal reflection.
The system consist of Master Antenna , matching transformer to match the balanced antenna with unbalanced cable and amplifiers.
There is no satisfactory workaround to the impedance issue in analogue systems, as impedance matching transformers do not pass DC, which is usually important.
Connection: 50 ohm coaxial cable soldered to antenna matching transformer and BNC connection to rear of receiver.
The Impedance Matching Room has a matching transformer to perform impedance matching between the transmitter and the antenna.
The Guanella transmission line transformer (Guanella 1944) is often combined with a balun to act as an impedance matching transformer.
The very high output impedance of valves (compared with transistors) usually requires matching transformers to drive low impedance loads such as loudspeakers or cutting lathe heads.
The amplifier delivered a 70 volt line type output that coupled to the speakers via 500 ohm matching transformers, mounted in the speaker inclosures at each locality.
To match the impedances of both devices, both cables must be connected to a matching transformer with a turns ratio of 2 (such as a 2:1 transformer).
The antenna coupling transformer also functioned as an impedance matching transformer, to match the antenna impedance to the rest of the circuit.
My only concern with this original old S15-T after I'd been using it for a few months was the overall mass of the cartridge due to the built-in stereo matching transformer.
Line passing through matching transformers, pair gain or RIM prior to customer premises (If your modem only typically connects at 24-26.4K, chances are you're in this group)
Speaker Matching Transformer This 100 watt rated auto-transformer is used to match multiple 8 or 4 ohm speakers to an 8 or 4 ohm amplifer output.