filler plug

Make sure the filler plug is tight and does not leak.

Then find the filler plug in the transfer case and check the fluid level just to make sure it isn't dry.

Because it was in use so long it is possible to get a drain but no filler plug.

This I later found out was from the gearbox, a faulty filler plug being the culprit!

Close all valves and fill the cold torch about 70% full of petrol through the filler plug on the tank.

It is best to wait some minutes after turning off the compressor before opening the filler plug or oil may froth over.

Always re-prime this tube after any removal of filler plug/luer connection.

Lock wire drain and filler plugs, oil filter.

If fitted, drain the water out of the hydrostatic lubricator after removing the filler plug.

Filler plugs are not required.

Check the oil level in the separator by unscrewing the filler plug at the front of the separator tank.

Loosen the filler plug.

If the oil level in your transfer case is above the level of the transfer case filler plug, investigate carefully why this is occurring.

It has a safety valve and a separate filler plug and overflow plug and is fitted with a whistle.

Left: Five early one piece rims, Above left: Front &rear diffs with early filler plug gearbox, transfer case and bell housing behind.

Please contact Scottoilers, quoting your warranty reference and the code etched on the RMV under the filler plug.

Type 72 has a telescopic carrying handle molded into the bottom of the mine and a large diameter filler plug on the side just above the handle position.

Base Crossfire models, both Coupe and Roadster, have black painted windshield frames, black filler plugs (in place of fog-lights) in the front fascia, and fabric seats with separate, movable headrests.

It states, among other specifications, that the warning label must be located within a certain distance of the brake reservoir filler plug or cap, and must indicate the correct type of brake fluid that should be used.

Check that the filler plug is flat and airtight on RMV and that the nylon luer at the top of the plug is connected properly (these push and twist on for an airtight seal).