The drill program establishes four drilling points of 300 meters each.

A. We have drill points, pestles and bowls that were found in this area.

When the drill point is just through, turn the mirror over and drill from the other side.

A face without a drill point indicates that the dowel hole is a press fit.

Cut out mounting bracket template on page 17 for location of drilling points.

Rocky moved the drill point to a new site, and looked at Cirocco suspiciously.

An extended drill point allows fixing to thicker steel sections.

It is a short drill point on a heavy drill shank or body.

But then the drill point moved forward.

He fired twice more, smashing the drill point before it could loose its own lethal greeting.

Hold that block in one hand, put the drill point where you want it, and draw the bow back and forth with the other hand.

Use the drill point gage frequently to check lip angle and lip length.

It is important that the drill point protrudes after drilling and is not fully encased by metal.

Align the center of the round stock with a square or by lining the workpiece up with the twist drill point.

Drill Point End Mills are manufactured from carbide.

A chrome-steel drill point.

Hi-Teks Drill Point: Hi performance cutting tip for accurate, faster and effortless installation.

From drill point control, thread detection and location checking to accurate edge detection and the replacement of fibre optics in difficult applications.

Mike Stephenson of the British Geological Survey is sceptical that accurate predictions can be made from Cuadrilla’s two drill points.

The rock surface had suddenly split open at the site of the drilling, separating into three lines that radiated away from the drill point and streaked for the horizon.

Because the drilling point cuts cleanly, a precise mating thread forms between the fastener and timber with less possibility of splitting or tearing of the timber.

A range of Deep Tillage and Direct Drilling Points and Adapters for the Agricultural Industry.

AF constructed a landfall tunnel system for Shell that was to connect to a drilling point located 3.6 km out to sea, and 200 meters below the sea level.

This operation must be completed before the drill point has enlarged the hole to full diameter or the surface of the workpiece will be marred by a double hole impression.

Cairn Energy has told Greenland authorities that it will continue moving its platform towards the agreed drilling point and it has not excluded asking police to evict the two activists.