When the stop event occurs, the charging current is stopped.

If the charging current is too low, the batteries will never recharge.

Thus, they will have higher charging currents, which helps in improving power factor.

By sampling the current just before the potential is changed, the effect of the charging current can be decreased.

At high charging currents, active cooling measures may be necessary to prevent overheating.

The charging current is low to prevent rapid production of gases that can rupture the cell.

(1) In these measurements, the effect of the charging current can be minimized, so high sensitivity is achieved.

Controlled battery chargers need to read the battery voltage in order to correctly limit the charging current delivered.

All capacitors are synchronously charged or discharged and none of the capacitors exchange charging currents.

When a capacitor charges from a fixed voltage source through a resistor, the charging current is not constant throughout the charging time.

Using smaller than specified transformers could result in reduced charging currents as well as burned out mains supplies (fire hazard).

Operations are more difficult since the high reactive power of underground cables produces large charging currents and so makes voltage control more difficult.

Power converters also often have inrush currents much higher than their steady state currents, due to the charging current of the input capacitance.

For example, some rural installations can offset line losses and charging currents with local solar power, wind power, small hydro or other local generation.

It is possible to charge a battery with pedal power where an achievable charging current may be about 10 Amps into a 12 Volt battery.

Capacitance currents (charging currents) occur between two electrodes, which are insulated from each other, one being at a different voltage potential than the other.

Each time it takes place, the charging current comes along at the right instant to give it a boost, so that the oscillations build up to tremendous values.

Charging is via a matched charger where continuous charging current is converted to an electronically monitored pulsating current.

Direct modulation is usually accomplished by varying a capacitance in an LC oscillator or by changing the charging current applied to a capacitor.

Charging Current Charging current is calculated from capacitance and voltage as follows:

However, as with all pulsed techniques, chronoamperometry generates high charging currents, which decay exponentially with time as any RC circuit.

The current is measured at the end of each potential change, right before the next, so that the contribution to the current signal from the capacitive charging current is reduced.

Changes of component values, e.g. resistors or capacitors, in secondary circuits do not usually have any safety critical implications unless the components involved limit charging currents or overheating.

The capacitive line charging current produces a voltage drop across the line inductance that is in-phase with the sending end voltages considering the line resistance as negligible.

In audio and due to power transfer with spike-shaped charging currents, power transformers have to be run with low flux densities in order to avoid saturation of the core.