working temperature

It can take up to 10 miles to reach normal working temperature, summer or winter.

The normal working temperature for the cooking oil was approximately 170°C.

Due to the low compression it was difficult to reach the working temperature.

Control of heat and cold should aim to lower or raise working temperatures to within this range.

It has, however, poor compression set and a high minimum working temperature.

Instead the low speeds mean the issue is keeping the brakes up to working temperature.

Their body heat would, it seems, have been sufficient to keep the mine's components at a working temperature.

To achieve best results, working temperatures should be between +5oC and +25oC.

Dual fans are used to help maintain a cooler working temperature.

The disadvantages include added expense, higher working temperatures, and increased time.

This is necessary in order to maintain the body at its normal working temperature of about 98 Fahrenheit.

Allow the hot side to come up to working temperature, then kick over the fly wheel(s).

Before starting each day the dies are preheated to approximately the working temperature.

The cooling rate is adjustable so that a comfortable working temperature can be maintained.

Consequently the effective working temperature will be higher than if the material was applied in a concentrated liquid form.

However, suitability for the working temperature must be observed.

It is usual to introduce impurities into the glass in the form of other materials to lower its working temperature.

Readjust the air settings for a safe working temperature.

Make sure reasonable working temperature is maintained at indoor work places during working hours.

In addition to allowing for selective application, its working temperature is almost six times that of urea.

The low working temperature leads to rapid cooling of the cast products and therefore fast assembly is possible.

Flammables will usually ignite and burn easily at normal working temperatures.

The burner output is throttled to maintain a constant working temperature.

Maximum working temperature depends on composition, stress and time at temperature.

The following table shows both working temperatures and ultimate tensile strength of Warton material.