In practice total harmonic distortion is not easy to measure, especially when small.

The highest generally acceptable level of total harmonic distortion is considered to be 0.1%.

Nobody could dispute the claim because it said, in small print, "measured at 10 percent total harmonic distortion."

Objectivists and Subjectivist were once at odds about the importance of total harmonic distortion.

The total harmonic distortion of the system is as low as 0.05 percent - comparable to a good home audio system.

Among the performance factors measured were frequency response, signal-to-noise ratio, total harmonic distortion and headroom.

Instead he chose THD, the acronym for "Total harmonic distortion".

THD+N means total harmonic distortion plus noise.

The modulation depth m is a convenient experimental parameter when assessing the total harmonic distortion in the demodulated signal.

While effective, total harmonic distortion for this technology was higher than Nakamichi's receivers utilizing Stasis technology.

Most manufacturers claim that their T5 ballasts have a total harmonic distortion (THD) of less than 15%.

They must meet receiver standards for low total harmonic distortion and proper NRSC-1 audio de-emphasis curve.

For moderate levels of distortion (such as five per cent) the distortion factor is virtually the same as total harmonic distortion.

Total harmonic distortion (THD)

Total harmonic distortion and noise (THD+N)

One active area of development is in the reduction of total harmonic distortion (THD) created by the rapid switching inherent to these algorithms.

Digital is also claimed to have a higher signal-to-noise ratio, a wider dynamic range, less total harmonic distortion, and a flatter and more extended frequency response.

Total harmonic distortion is sometimes expressed as the sum of all the harmonic power expressed as a percentage of the fundamental power.

Total Harmonic Distortion (THD)

In such cases, CFLs with low (below 30 percent) total harmonic distortion (THD) and power factors greater than 0.9 should be selected.

Generally well-done mixes do not need stem-mastering as this process potentially magnifies the noise floor and amount of total harmonic distortions (THD).

In September 1945 the company released the first of the "Point One" series of amplifiers, so named because the total harmonic distortion was 0.1% at rated output.

The quality of the inverter output waveform can be expressed by using the Fourier analysis data to calculate the total harmonic distortion (THD).

The maximum SPL the microphone can accept is measured for particular values of total harmonic distortion (THD), typically 0.5%.

The results were subwoofers with over 3000 watts of dynamic power that deliver clean, accurate, high-impact sound from 15 to 120 Hz with total harmonic distortion below .5%.