specific humidity

Despite requiring very specific humidity and heat, this species is commonly found in the pet trade.

Typically, there are deep pockets of saturation, which requires very low specific humidity.

Specific humidity can be expressed in other ways including:

This species does well in captivity despite requiring a very specific humidity and temperature habitat.

Drying generally requires very low specific humidity to accomplish drying.

The measurements are usually expressed as specific humidity or percent relative humidity.

The figure shows conditional probability versus specific humidity for the example retrieval discussed above.

The atmospheric mixed layer is a zone having nearly constant potential temperature and specific humidity with height.

Clabber is a food produced by allowing unpasteurized milk to turn sour at a specific humidity and temperature.

At a given barometric pressure, independent of temperature, the dew point determines the specific humidity of the air.

These include vapor pressure, specific humidity, mixing ratio, dew point temperature, and relative humidity.

Specific humidity is a ratio of the water vapor content of the mixture to the total air content on a mass basis.

However, specific humidity is also defined as the ratio of water vapor to the total mass of the system (dry air plus water vapor).

The etymology of "Lungrum" or "Ugrium" seems to refer to the specific humidity of its territory.

(specific humidity: see) humidity (see under Specific Humidity)

Note that many texts use mixing ratio r in place of specific humidity q because these values tend to be close (within a few percent) under normal atmospheric conditions, but this is an approximation and not strictly correct.

The RH of air increases when it is cooled, since the amount of water vapor in the air (i.e., its specific humidity) remains constant, while the saturation vapor pressure decreases almost exponentially with decreasing temperature.

Specific humidity is defined as the proportion of the mass of water vapor per unit mass of the moist air sample (dry air plus the water vapor); it is closely related to humidity ratio and always lower in value.

A dry state is determined when the exhaust specific humidity drops below intake specific humidity at which stage the heater and machines air exchange fans are automatically turned off and the technician notified by email or text that the building is dry.