Settling time is measured to a level closer to the final value.

After some settling time the read head begins to pick up bits.

If the water is very cold or cloudy, increase the settling time before using it.

Phase shifter settling time on the order of 50ns is required.

Watch out for settling time when one of the input voltages changes, though.

Settling time depends on the system response and time constant.

Setting a value for is often a trade off between decreasing overshoot and increasing settling time.

You'll notice that I say end of the fortnight, that was the settling time.

Specific criteria for command tracking include rise time and settling time.

Accumulated sediment is observed and measured fifteen minutes later, after one hour of total settling time.

After a half second of settling time, the F-16's airframe suddenly gave a savage lurch.

Overshoot often is associated with settling time, how long it takes for the output to reach steady state; see step response.

The following gives the maximum permissible settling time for antenna phase shift modules.

Absorbing vibrations decreases the settling time the system needs, which increases through-put.

Electrical noise and settling times were major issues, and Orion was much slower than promised.

Transient response: Like overshoot and settling time to a certain accuracy (like 50ppm).

The Step response characteristics applied in a specification are typically percent overshoot, settling time, etc.

Feature single supply, low current operation with rail-to-rail outputs and programmable settling times.

If α is increased by lengthening τ1, the settling time 't'S is little altered.

They also allow a faster settling time because of their higher reference frequencies, allowing wider closed and open loop bandwidths.

Finally the settling time is the time taken for oscillation to decay so that the system is within 5% of the target.

Derivative action predicts system behavior and thus improves settling time and stability of the system.

By this rule, a reference frequency of 50 kHz has a settling time of 1 milli-seconds.

In signal processing terms, it compensates for the fall time and settling time following the sync pulse.

That suggests that a specification on settling time must be met by appropriate design of the open-loop amplifier.