line output

This high-pitched whistle is caused by magnetostriction in the line output transformer.

Line inputs are designed to accept voltage levels in the range provided by line outputs.

Earlier designs used a separate line output transformer and a well insulated high voltage multiplier unit.

Headphone outputs and line outputs are sometimes confused.

Thus the plant "combined mills, jiggering units, conveyors, dryers and kilns into a model of straight line output."

The hub has a line output for direct connection to stereos with audio inputs, and an FM modulator to broadcast music to stereos without them.

Effectively, a headphone amplifier is a small power amplifier that can be connected to a standard headphone jack or the line output of an audio source.

Peaucellier-Lipkin linkage, the first planar linkage to create a straight line output from rotary input; eight-bar, one DOF.

Direct current (DC), is switched though the line output transformer, and alternating current (AC) is induced into the scan coils.

A flyback transformer (FBT), also called a line output transformer (LOPT), is a special type of electrical transformer.

When connected to a host computer via USB, the H2 can act as a microphone, audio input (with microphone or line input) and output device with stereo line output.

Audio output used a Burr-Brown PCM1716 DAC that drove line outputs, the headphone jack, and a Tripath class-D digital audio amplifier for speakers.

An example supply from a 1980s TV used bidirectional interaction between the main supply and the line output stage to operate, generating a range of output voltages with varying amounts of stabilisation.

Pre-2.0 versions of the OS had command line output only for common utilities like "format" and "switch", while later versions included forms-based versions of these utilities, greatly improving their usability.

The voltage was not high enough to power some circuits, so energy was recovered during the flyback period from the primary of the line output transformer to provide a boosted HT (high tension) supply.

Transistor line output stages, although not requiring supply voltages above the rectified mains voltage, nevertheless still developed extra voltage over the normal supply rail to avoid complicating the power supply circuitry.

Rear panel connections are as you'd expect: a pair of stereo line outputs, recording outputs, parallel effects loop with mono send/stereo returns, and a series loop with single send and return sockets.

The unit has 2 inputs which can be used both as phono or line input, but unlike the old SL1 interface it doesn't have a microphone input and it has only 2 line outputs and no 'thru' outputs.

At low current densities, krypton's spectral line output in the near-IR range is better matched to the absorption profile of neodymium based laser media than xenon emission, and very closely matches the narrow absorption profile of Nd:YAG.

It has passive and active input jacks, gain and master volume controls, an 'aural enhancer', a tuner input, tone controls for bass, midrange and treble, an effects blend control, clip indicators for both the preamp and power amp and a balanced line output.

When driven by a line output's usual low impedance of 100 to 600 ohms, this forms a "bridging" connection in which most of the voltage generated by the source (the output) is dropped across the load (the input), and minimal current flows due to the load's relatively high impedance.

The reverse flow, short duration, (about 10% of the line scan time) current from both the line output transformer and the horizontal scan coil is discharged again into the primary winding of the flyback transformer by the use of a rectifier which blocks this negative reverse emf.

A typical modern design incorporates the flyback transformer and rectifier circuitry into a single unit with a captive output lead, (known as a diode split line output transformer or an Integrated High Voltage Transformer (IHVT)), so that all high-voltage parts are enclosed.

In the case of high-powered audio applications requiring long cables to the load - e.g. cinemas and shipping centres - instead of using heavy gauge cables it may be more efficient to connect to the load at line output voltage with matching transformers at source and loads.