Dimensional tolerances are usually 2 to 5% of the overall dimension.

This process is designed to achieve the desired dimensional tolerances of the forged parts.

Dimensional tolerances should not be closer than necessary.

It maintains dimensional tolerances and does not create burrs or sharp edges.

In other words, if a process can manufacture parts to a narrow dimensional tolerance, the parts will not be very rough.

High precision is required to ensure the canoe meets the dimensional tolerances set by the competition.

The process can also be highly automated, provides strict control over dimensional tolerances and does not interfere with the biocompatibility of parts.

The dimensional tolerances of a steel part produced using the impression-die forging method are outlined in the table below.

Therefore, it is most economical to plan the largest sheet size possible consistent with the size and dimensional tolerances of the part.

The product shipped from Plant 6 must pass rigid inspection for dimensional tolerances, metal quality, and surface conditions."

It's only dimensional tolerances don't forget.

Remington used the same steel and heat treatment as for the M1917 rifles, although improving the dimensional tolerances and the standard of finish.

Welded pipe often has tighter dimensional tolerances than seamless, and can be cheaper if manufactured in the same quantities.

Very tight weight and dimensional tolerances can be obtained on wheel equipment, as the parison is captured on both ends.

Dimensional tolerance is related to, but different from fit in mechanical engineering, which is a designed-in clearance or interference between two parts.

Accuracy of coupling factor depends on the dimensional tolerances for the spacing of the two coupled lines.

CAQ (computer-aided quality) is used for tasks such as Dimensional tolerance (engineering) analysis.

Surface Tolerances A report from a Board project on dimensional tolerances for accessible surfaces is now available.

SAAMI recommended chamber dimensional tolerance range does allow for the headspacing to take place on the shoulder if need be.

This process is good for large production runs at economical cost, but produces geometric shapes with less strength than other moulding processes and has poor dimensional tolerance.

To facilitate manufactureability, a feature control frame is often used to assign a dimensional tolerance to the feature that is referenced in by the basic dimension.

It also introduced a number of minor design changes in certain parts of the action, allowing increased dimensional tolerance (kbk wz.29 all parts are fully interchangeable.)

The use of overlap in the former reduces the variation seen in bead size, meaning that precise dimensional tolerances needed for industrial installations can be maintained better.

The Schneider design was very complex and expensive to build, requiring very tight dimensional tolerances which were beyond the limits of Japanese industry to sustain at the time.

The polymeric materials have much greater durability than plaster and, therefore, it is possible to achieve shaped products with better dimensional tolerances and much longer mould life.