debond

Bend the debond steel so that it is inside the notch in the first plate.

Lay the cable out and assemble the debond sections.

If a debond occurs, determine where it happened and classify the failure as:

The experimental study was conducted to determine debond growth under static monotomic loading.

It sets out the recommended process for designing a beam, including when to debond and deflect tendons.

Install the second plate, making sure that the debond steel and lead wires will not get pinched when the cable is tightened.

This causes them to move at differing speeds and debond from adjoining particles and the surface that they are adhering to.

Both a double cantilever beam (mode I) and a mixed mode skin-stiffener debond configuration were studied.

The experimentally determined debond length vs. applied load was used an an input parameter in the finite element analysis of both configurations.

The cause was improper installation of the wing fabric, causing it to debond, resulting in aileron/wing flutter.

Release agents are not required as CPF liners easily debond from the concrete during formwork striking.

The Sunday Telegraph reported last year that Danny Debond, 76, had had a claim refused after he fell ill on a holiday in India.

"It's such a treat," said Rockdale Elementary principal Desiree DeBond Vargas, whose students look forward to it all year.

Make sure that the debond steel doesn't exit the borehole collar at a joint between two pieces, as this could result in cutting the leadwires in step 4 below.

The observations showed that, for all three load cases, failure initiated in the flange, near the flange tip, causing the flange to almost fully debond from the skin.

The stitches were shown to delay the initiation of the debond and provide load transfer beyond the load necessary to completely debond the stitched lap joint.

Glass-ionomer cements are a promising bonding alternative to resin composite in that they maintain the integrity of the enamel, are easier to debond, and prevent enamel decalcification adjacent to the bonded bracket.

Mr Debond's brokers contacted the insurer, which agreed to pay the claim in full, and Mr Debond has since persuaded his doctor to remove the condition from his record.

The fibres must also be kept separate from each other so that if failure occurs it is localized as much as possible, and if failure occurs the matrix must also debond from the fibre for similar reasons.

Mr Debond had suffered from asthma all his life and declared the condition when he applied for the insurance, but his medical records described the condition as COPD, or chronic obstructive pulmonary disease, which is much more serious.

Steel CSL tubes are preferred over PVC tubes because studies have shown that PVC tubes tend to debond from the concrete due to the heat of hydration process of concrete, resulting in erratic CSL test results.