applied voltage

However, when applied voltage is large, this force needs to be considered.

For example, higher temperature and applied voltage cause the failure rate to increase.

The degree of transparency can be controlled by the applied voltage.

Further, the current only increases significantly if the applied voltage is positive, not negative.

With no applied voltage, the micro-blinds are rolled and let light pass through.

When the potential associated with the charge exactly balances the applied voltage, the current goes to zero.

As the applied voltage increases we expect to see deviations from linear behavior.

Thus the applied voltage is the primary control for the amount of film applied.

This means that the motor has no theoretical maximum speed for any particular applied voltage.

Ions only pass through the chopper when there is no applied voltage.

Field weakening is done when the maximum speed cannot be reached by increasing the applied voltage.

Current and lifetime change greatly with a small change in applied voltage.

Capacitors in a parallel configuration each have the same applied voltage.

The relation between current and applied voltage illustrates the nature of the photoelectric effect.

The higher the applied voltage, the lower the permittivity.

The applied voltage employed at each time step is also recorded to provide an indication of relative power consumption.

Using a higher applied voltage will generate larger diameter and more branched figures.

It is important to vary the applied voltage such that the response falls within a critical proportional range.

As seen in the figure, the current does not increase linearly with applied voltage for a diode.

The capacitance value also depends on the applied voltage.

The applied voltage was varied and the experiment repeated.

Means shall be provided for continuously shifting the phase angle of the applied voltage.

A laser was used to determine how the device bends under the influence of small applied voltages.

The leakage current depends on the applied voltage and the ambient temperature.

The same setup can be used to instead measure the work function in the collector, simply by adjusting the applied voltage.