The internal thermal resistance is also a point of contention.

However, thermal resistance per unit price is much less than conventional materials.

And additionally, the thermal resistance of the heat sink will also increase.

It is used when strength, thermal resistance and safety are important considerations.

The data for the thermal resistance and heat transfer coefficient are shown in Figure 14.

High thermal resistance can also be achieved with multilayer systems.

Another surprising behavior of the thermal resistance was observed in the pressure dependence.

R-value is the term given to thermal resistance to heat flow.

The R-value is a measure of thermal resistance used in the building and construction industry.

Its thermal resistance is also superior to that of PA 12.

The thermal resistance then results from the transfer of phonons across the interface.

It creates a lot of heat, so companies using it will need materials with a greater thermal resistance.

Thermal resistance is the ability of a material to resist the flow of heat.

Working in units of thermal resistance greatly simplifies the design calculation.

Reducing the thermal resistance of the resistors keeps the temperature rise small.

The R-value being discussed is the unit thermal resistance.

Thermal resistance and sound transmission vary greatly between fiber cement products.

It is widely used in place of polystyrene owing to its greater thermal resistance.

The thermal resistance due to the pipe wall is calculated by the following relationship:

The higher the thermal resistance of a part of the building envelope is, the slower the heat loss.

On the other hand, anodizing or etching will also decrease the thermal resistance.

That means its thermal resistance depends on the direction of heat flow relative to the wood grain.

The sum of these resistances is the total thermal resistance from the die to the ambient.

Increasing the thickness of an insulating layer increases the thermal resistance.

It is also used for components of turbochargers because of its thermal resistance.