They have a total of three or six fan blades.

Next, place the fan blades on a table to make sure they are flat.

The fan blades from the engine are several feet long.

To produce the best results, fan blades should be no more than nine feet above floor level.

The pressure ratio of a single fan blade is too low and cannot be used.

Sometimes we take out a fan blade on a reef.

One must've hit a fan blade before it sang away.

The only way to the starter is through the fan blades.

It is no longer used for ceiling fan blades in most countries.

He turned his attention back to the churning fan blades.

Right now all I care about is whether you can slow these bloody fan blades down enough for us to get past them.

Problems with the fan blades delayed testing this summer for about six weeks.

"Some of the fan blades were still attached to it.

One of the critical limits on fan blade performance is their "stall point."

Do not pull on the metal shaft at the centre of the fan blades.

This is already being used to make the large fan blades at the front of some jet engines.

The nearest wall should be at least 24 inches from the ends of the fan blades.

He used the fan blades on the third and fourth wingnuts, too.

It's tail was up in the air and there were fan blades laying all around on the ground.

Placed closer, fan blades lose half or more of their circulating ability.

The aircraft would use an unusual engine with external fan blades.

Still missing is a 300-pound titanium disk that held the fan blades.

Lay the fan blades flat on a table and check for warping.

Ideal for painting the inside of your case, individual components, fan blades, etc.

The fan blades are sucking in the air like a big vacuum cleaner.