Dodatkowe przykłady dopasowywane są do haseł w zautomatyzowany sposób - nie gwarantujemy ich poprawności.
This allows a much tighter control of the breakdown voltage.
For a certain pressure x distance value, there is a lowest breakdown voltage.
This breakdown voltage in common cells is between 10 and 30 volts.
The resulting breakdown voltage is calculated as mean value of the individual measurements.
Breakdown voltage is also affected by pressure, humidity and temperature.
Their breakdown voltage will be much lower than plastics with no metal powder in them.
When a value is given it is usually the mean breakdown voltage of a large sample.
In a solid, the breakdown voltage is proportional to the band gap energy.
II: glow discharge, which occurs once the breakdown voltage is reached.
The breakdown voltage can be controlled quite accurately in the doping process.
The reverse bias breakdown voltage to the base may be an order of magnitude lower in this region.
Intermediate breakdown voltages (around 5V) are usually caused by a combination of the two effects.
Wide bandgap semiconductors are associated with a high breakdown voltage.
The breakdown voltage of gases is roughly proportional to their density.
The lower the resulting breakdown voltage, the poorer the quality of the transformer oil!
Zener diodes have a certain - low - breakdown voltage.
But the breakdown voltage for dielectric films is usually nonlinear.
The breakdown voltage of film capacitors decreases with increasing temperature.
For the same reason, high insulation resistance and high breakdown voltage are required.
Unfortunately, these devices may have higher breakdown voltages and longer response times than varistors.
The thicker the layer and the lower its doping level, the higher the breakdown voltage.
E1 causes most of its damage by causing electrical breakdown voltages to be exceeded.
The optical channel is made as thin as possible for a desired breakdown voltage.
In a gas, the breakdown voltage can be determined by Paschen's Law.
As the pressure increases, the distance between the electrodes must decrease to achieve the same breakdown voltage.